PDA

View Full Version : How to set up a Motorized KU Band dish



AcWxRadar
10-10-2009, 01:16 PM
I composed this tutorial manual as a "How-To" for all FTA junkies to use to set up their small diameter Ku motorized dish antennas a few years ago.

It is lengthy, but give it a read and see if it helps you with your endeavor. I think I put in some good information here.

It is directed towards a Coolsat 5K/6K FTA receiver owner, but you can obviously adjust the specifics in menu setups to your own make and model.

I know more now then I did when I wrote this, but I think it all still applies, I am hoping that you will find it informative and helpful.

RADAR

SatelliteAV
10-10-2009, 02:09 PM
Here are the motorized install instructions that we provided several years ago for Fortec Star Lifetime Ultra, Fortec Star Mercury II and Visionsat IV-200 receivers using the GEOSATpro GS120 motor.

Hope that these might help someone with their install!

wescopc
10-11-2009, 02:17 PM
I composed this tutorial manual as a "How-To" for all FTA junkies to use to set up their small diameter Ku motorized dish antennas a few years ago.

It is lengthy, but give it a read and see if it helps you with your endeavor. I think I put in some good information here.

It is directed towards a Coolsat 5K/6K FTA receiver owner, but you can obviously adjust the specifics in menu setups to your own make and model.

I know more now then I did when I wrote this, but I think it all still applies, I am hoping that you will find it informative and helpful.

RADARRadar I converted your Word Doc to a PDF - it is attached for those who prefer PDF's:)
Bob

Reigster at SatelliteGuys