Results 1 to 10 of 19
- 12-28-2009 09:46 PM #1
SatelliteGuys Junkie
- Join Date
- Jan 8th, 2005
- Posts
- 3,258
4dtv 922 - No analog - No digital
ADVERTS 1
It seems my 4dtv 922 is now just a dish mover.
I wanted to watch the analog Directv satellite launch and discovered that I only get snow on all analog channels. I tried DC2 channels and I get no lock. Signal is 100 and Quality is 99 on all DC2 channels that I checked. The signal occasionally drops to 10 and then back to 100. The lnbs are fine as my FTA receivers all work as does the Broadlogic Spectrum analyzer. They are connected via splitters with power passing to the 4dtv. Anyone have any idea what is causing this?
- 12-28-2009 09:46 PM # ADS
Register Today & This Ad Goes Away! Circuit advertisement- Join Date
- Always
- Posts
- Many
- 12-28-2009 09:50 PM #2
for analog have you tried a known 24/7 analog channel like Shepherd's Chapel (G4 16V)
Winegard 76cm dish, SG2100 motor, Sadoun dual KU LNB..... Directv Slimline SWM 3 LNB.... GeoSatPro 36" dish with Sadoun dual KU LNB... Coolsat 5000 on motorized.... Manhattan RS1933....Directv HR34 (yes the 5 tuner monster) GeoSatPro 200 to aim dishes.... few receivers not set up yet
Two 6 foot Fortec dish with GeoSatPro dual C-Band LNB "ghetto moved" to various C-Band satellites
- 12-28-2009 10:00 PM #3
SatelliteGuys Junkie
- Join Date
- Jan 8th, 2005
- Posts
- 3,258 Thread Starter
I tried PBS on AMC 2/4 and a few others that I could see on the Broadlogic Spectrum analyzer.
- 12-28-2009 10:02 PM #4
bad splitter?
If it jumps from 99 quality to 10 then back to 99 sounds like a short somewhereWinegard 76cm dish, SG2100 motor, Sadoun dual KU LNB..... Directv Slimline SWM 3 LNB.... GeoSatPro 36" dish with Sadoun dual KU LNB... Coolsat 5000 on motorized.... Manhattan RS1933....Directv HR34 (yes the 5 tuner monster) GeoSatPro 200 to aim dishes.... few receivers not set up yet
Two 6 foot Fortec dish with GeoSatPro dual C-Band LNB "ghetto moved" to various C-Band satellites
- 12-28-2009 11:08 PM #5
SatelliteGuys Junkie
- Join Date
- Jan 8th, 2005
- Posts
- 3,258 Thread Starter
I removed the splitters and still no analog or digital. I'm thinking the tuner is bad or maybe it's not getting power?
- 12-28-2009 11:12 PM #6
possibly?
Even if the battery died in it the analog channels should still work. This is weirdWinegard 76cm dish, SG2100 motor, Sadoun dual KU LNB..... Directv Slimline SWM 3 LNB.... GeoSatPro 36" dish with Sadoun dual KU LNB... Coolsat 5000 on motorized.... Manhattan RS1933....Directv HR34 (yes the 5 tuner monster) GeoSatPro 200 to aim dishes.... few receivers not set up yet
Two 6 foot Fortec dish with GeoSatPro dual C-Band LNB "ghetto moved" to various C-Band satellites
- 12-28-2009 11:29 PM #7
SatelliteGuys Junkie
- Join Date
- Jan 8th, 2005
- Posts
- 3,258 Thread Starter
I recently replaced my 7 1/2 foot dish with a 10 foot dish. I had to pull the 4dtv out to swap the M1 and M2 wires around because the motor on the actuator that came with the 10 foot dish ran the wrong way when I installed it. I'm not sure if the problem started after I replaced the dish or if it happened before and I had not noticed it. I have no DC2 subscriptions and I don't usually watch the analog channels.
- 12-29-2009 07:49 AM #8
SatelliteGuys Guru
- Join Date
- Mar 9th, 2007
- Posts
- 6,872
Something could have happened the 4DTV's tuner. You could see if the connector broke off the circuit board.
- 12-29-2009 04:41 PM #9
SatelliteGuys Junkie
- Join Date
- Oct 31st, 2005
- Location
- Mesa, AZ
- Posts
- 1,333
- 12-29-2009 05:04 PM #10
photoman
did you figure it out or are you still having issues?Winegard 76cm dish, SG2100 motor, Sadoun dual KU LNB..... Directv Slimline SWM 3 LNB.... GeoSatPro 36" dish with Sadoun dual KU LNB... Coolsat 5000 on motorized.... Manhattan RS1933....Directv HR34 (yes the 5 tuner monster) GeoSatPro 200 to aim dishes.... few receivers not set up yet
Two 6 foot Fortec dish with GeoSatPro dual C-Band LNB "ghetto moved" to various C-Band satellites

LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks