Thread: Recommended Power inserters or workaround using dual C/KU feedhorn??

I am wondering if any of you can recommend a decent power inserter to provide 18v to both legs on a Chapparal Bullseye 2 feedhorn???
Or have you found that your receiver handles both legs at 18v with one not dropping to 13v?? I heard some receivers did not have that problem, or that it at least did not affect performance that much.. and I heard others talking that they are using as is without problems but I think it would be best to keep it all at 18v for top performance and not worrying about burning up expensive lnb's
I see power inserters on the marketplace, but I'm sure some of them are crap and others not.
I would appreciate any hands on info, or perhaps other suggestions, workarounds or drawings on a reliable way getting 18v at all 4 lnb's on the Bullseye 2 Feedhorn
thanks, HB

Stogie sent me this link to the discussion here... Sorry I added a thread that was already covered. I was searching but not with the correct info..For anyone else looking for this info, here are the links to the threads below that Stogie sent me... Over n out, HB

These links:

http://www.satelliteguys.us/fta-shac...v-outputs.html

http://www.satelliteguys.us/c-band-s...h-show-me.html

While I prefer the two threads above, here is one more converting a regular multiswitch to a powered one.
Naughty Mods III: 6x8 Switch with Power Insertion