Results 1 to 3 of 3
Thread: Two rcvers One Antenna
-
LinkBack
LinkBack URL
About LinkBacks- Bookmark & Share
- Digg this Thread!
- Tweet this thread
- 02-04-2012 11:45 AM #1
- Join Date
- Dec 2nd, 2005
- Location
- tennessee
- Posts
- 38
Two rcvers One Antenna
ADVERTS 1
I'm sure someone has already figured this out. Is there any way to set up two rcvers to control the same cband ant 1.2 diseqc set up via a vbox. I have it working great with one rcvr now. Would like switch the control between two rcvrs(not at the same time). I figure one would forget where it had the positioner if I didn't remember to put it back where the second one took over. Any thoughts?
- 02-04-2012 11:45 AM # ADS
Register Today & This Ad Goes Away! Circuit advertisement- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
- 02-04-2012 12:16 PM #2
SatelliteGuys Junkie
- Join Date
- Feb 27th, 2010
- Location
- 97W 48N
- Posts
- 2,018
Shouldn't matter, the actual position is stored in the mover, only the position address (o6, 43 etc) is stored in the receiver. Use a dual power pass splitter to isolate the receivers from one another. Just have to make a satellite selection when changing which receiver is turned on.
One night I walked home very late and fell asleep in somebody's satellite dish.My dreams were showing up on TV's all over the world. -- Steven Wright
Openbox S9, Pansat 9200+S2(Sick), Pansat 3500SD, 139w to 55.5W +30W
- 02-04-2012 04:06 PM #3
- Join Date
- Dec 2nd, 2005
- Location
- tennessee
- Posts
- 38 Thread Starter
Fat Air, Thank you sir, why didn't I think of that. Sometimes the old nogging just don't function like it used too
. Will have to look around here and see if I have a dual pwr pass splitter to isolate the two boxes from each other. The Bull
Reply With QuoteTags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Bookmarks