Upgraded to dish 1000.2, can't get 522 rcvr back up

[stone phillips420]

Ok bob
take a look at this .pdf need adoe acrobat reaader to see, it free


http://www.prosatellitesupply.com/PD...ide_1000.2.pdf

take a look at pages 5-8

[Laddyboy]

Looking at the install guide that was linked to, are the cables going to your 522 receiver the ones from the 119 and 129 ports?

[OK Bob]

Looking at the install guide that was linked to....
#2 Port(110) is actually delivering the satellite channels from the 119 satellite
#1 Port(119) is delivering the channels from the 129 satellite.....and
the #3 Port(129) which you might guess had the channels from satellite 110, actually doesn't have anything on it.

[HIFI]

oh ok that clears things up a bit! your dish needs to be repointed,you need to raise your elevation up 4 and swing back to the east a bit

[OK Bob]

Regardless of dish pointing....shouldn't these switch outlets have the same output.

[Laddyboy]

Both should be the same. Do you have uninterrupted cable runs from the LNB ports to the receiver. There cannot be any splitters or switches along the way. For some reason the switch built into the 1000.2 LNB doesn't seem to be working. Did the LNB assembly come with the antenna (dish)? Try disconnecting the cables at the receiver and running a Check Switch to clear the matrix. Reconnect the cables and run another Check Switch test. Are the two matrices still different?