Lost OTA Signal

[cpapjack]

I have a 722 receiver connected via HDMI to my TV and I also have an OTA antenna connected to the receiver. My question is this: I had to disconnect everything to install my new tv and stand last week, and since then, I no longer have my OTA channels. If I try to re-scan, it comes up with nothing. I checked all of the connections coming from the antenna and all are good. Is is possible the OTA tuner went bad?

[KAB]

Are you sure you did not hook the antenna to the UHF antenna port? Analogue type set to AIR, not cable?

[cpapjack]

Are you sure you did not hook the antenna to the UHF antenna port? Analogue type set to AIR, not cable?

I am certain that it's connected to the correct port. I am not certain the Analogue type is set to AIR though. I will have to check that when I get home later.

[Voyager6]

You could hook the OTA line directly to your TV to check for signal. If you are getting a signal through the OTA line, try a power button reset on your receiver. You could also try deleting all the OTA channels and then try a re-scan.

[cpapjack]

You could hook the OTA line directly to your TV to check for signal. If you are getting a signal through the OTA line, try a power button reset on your receiver. You could also try deleting all the OTA channels and then try a re-scan.

Yeah, I thought about connecting the OTA line directly to my TV, but the cable isn't long enough. It'd be a bit of work to get a line long enough to reach and that will be my last resort if it comes down to that.

I have tried resetting the receiver already and I did try re-scanning, but I didn't delete the OTA channels prior to doing that. I will try that if KAB's suggestion doesn't work or isn't the case.