Can I move one receiver?

[nsafreak]

pft.. I wouldn't worry about anyone calling to verify someone who just has 2 boxes, you get this from 4 or more. As for the locals the answer is a new account each location that way you get the locals per the programming. I wouldn't do that though, just keep both boxes on same account and do OTA at the other location to pull in your other locals.

Well he's going to have a total of 6 tuners on his account although one of them will only be able to be hooked up to one television set. That is quite likely to set off some triggers for the audit team to give him a call at some point in time if they aren't hooked up. Insofar as only two boxes not generating a call I wouldn't count on that. There were a few folks in the old receiver audit team thread that's buried somewhere on this forum that were called and only had one or two receivers.

[nsafreak]

I've got a 622 right now and the two new receivers are coming later this week, one will be either a 622 or 722 and the other will be a 612. I'm not savvy with hooking things up so I wonder how much of a stink it would cause if either or both receivers did not get a signal.

With that setup you're highly likely to get a call from the receiver audit team at some point in time if they are not hooked up to the internet or a phone line. On the bright side those are all DishComm compatible receivers so hooking them up is a bit easier. All you have to do is setup DishComm on one receiver that's close to your wireless router and just run a CAT 5 cable from the receiver to the router. Failing that you could always just get a wireless access point if you don't feel like turning a router into one by loading alternate firmware and have a connection that route as well.