Dish 1000 setup

[sdsumann]

I curently am looking at re-doing my dishnetwork setup. currently i have this
input tv2 output
Dish 500 -------DP33 swtich -----------522----------splitter----all other
Dish at 148 ------- ----------- tv outlets


I want to have this
input tv2output
D1000-------------------Diplexer-----------Diplexer----SBC ----back
Square Shooter Antenna-- ----mediaportal fedto
same
line

So basically I want to know if you can have the dp1000 signal and a diplexed antenna on the same line which is split by a dpp seperator for a two tuner receiver then backfeed an rf output (like chanel 80) back on the same rg6 line that it came down from?

[Stargazer]

There are Dish Network approved diplexors that you can purchase at your local retailer.

[SimpleSimon]

You can run into trouble trying to combine OTA and a TV2 backfeed on the same line.

There are several pitfalls. I'd avoid it unless 100% impossible (not just hard) to avoid.

[sdsumann]

is it even possible to have 2 sat feeds and ota on one rg6 then back feed?

[dwain]

no u cannot do that it would involve2 many in put feeds for sat sig diplexers only have i sat input and 1 antenna so that would be the backfeed how would u put all 3 into it