Results 1 to 5 of 5
Thread: IR remote not responding
-
LinkBack
LinkBack URL
About LinkBacks- Bookmark & Share
- Digg this Thread!
- Tweet this thread
- 03-09-2010 10:44 AM #1
SatelliteGuys Freshman
- Join Date
- Feb 5th, 2010
- Location
- buffalo,ny
- Posts
- 6
IR remote not responding
ADVERTS 1
I was wondering if anyone else is having a problem with there number 1 IR remote not changing addresses? I received a few calls this morning about this.Every time I went to change the address on the primary the secondary would change and ideas on why this is happening.
- 03-09-2010 10:44 AM # ADS
Register Today & This Ad Goes Away! Circuit advertisement- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
- 03-09-2010 01:36 PM #2
SatelliteGuys Junkie
- Join Date
- Aug 19th, 2005
- Location
- Some old corn field, United States
- Posts
- 1,137
Receiver in single mode?
Sometimes I miss the old days when we had three channels on the TV, Back then I went to bed at a decent time.
- 03-09-2010 02:04 PM #3
SatelliteGuys Freshman
- Join Date
- Feb 5th, 2010
- Location
- buffalo,ny
- Posts
- 6 Thread Starter
nope the ones i checked were in dual mode , had them switch back and forth on the mode but still the #1 remote was changing the uhf address was wondering if ti was a glitch or something else was going on.
- 03-10-2010 12:12 AM #4
SatelliteGuys Junkie
- Join Date
- Nov 18th, 2003
- Location
- Los Alamos, NM
- Posts
- 1,532
Do menu+menu. Are both remotes set to the same address? If so, then you need to change just one, say the RF one by using RF remote to: Sat for 5 sec, address (1 to 16 or more), press #, view 3 flashes. Then go back and change the IR remote as desired to a different address. Avoid address 1 unless you are using IR from a non-Dish remote with Dish "pre-programmed".
-Ken
- 03-10-2010 08:03 AM #5
SatelliteGuys Freshman
- Join Date
- Feb 5th, 2010
- Location
- buffalo,ny
- Posts
- 6 Thread Starter
I tried that and remote2 was changing address then went back to remote one to try to readdress the same number then a few different numbers and it still was changing the uhf address still doesnt make any sense why this was happening.
Reply With QuoteTags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Bookmarks