Thread: QQ-Box USB DVB-S Tuner - Unknown Device?

I recently purchased a QQ Box to use with freesat. However, using a universal usb it was locked on to high band due to the L101 problem. The answer was to carefully remove L101 by gently prizing it with a small screwdriver while de-soldering each leg alternately and then glueing the inductor upside down on the other side of the board near the lnb socket. After re-connecting L101 with two fine wires the box works well. This way you don't have to buy the Murata Inductor. The problem was that placing the two inductors side by side created a transformer which coupled a permanent signal from the switched mode power supply to the tuner.
I'm using XP with the Sharp driver supplied with the box and Next PVR.

Hello all guys in this thread...I need to ask.....Did QQ Box can use this kind LNBF ? QQ Box Support that LNB'S Autoswitch ?Sorry for my my bad english n my newbie question....

Originally Posted by v4iciny

Hi all!
I have installed in debian, arch linux and now in lasted ubuntu and in all i have the same problem. I have cuts in the image and sound, seems to be the signal low, or a short buffer, I don't know. In other sofware like Kaffeine or me-tv, witch the same driver the device work successful, It's strange!

I have tried VDR, the problem is that it keeps trying to change pids while the streamer is running. I am not sure what it is doing, but it gets to the sixth pid entry and keeps swaping for pids on other channels.

Unfortunately, the firmware does not support this.

The only soultion is to turn the pid filter off with

dvb-usb-lmedm04 pid=1

You can put this in /etc/modules (or /etc/modules.preload) file, so to always boot with the pid filter off.

Originally Posted by tvboxspy

I have tried VDR, the problem is that it keeps trying to change pids while the streamer is running. I am not sure what it is doing, but it gets to the sixth pid entry and keeps swaping for pids on other channels.

It appears that VDR examines other channels on the transponder with last PID entry.

Changing PID stalls the streamer, then the PID filter starts it again.

Again, the only way to overcome this is to turn the PID filter off.

tvboxspy
have you any solution to use the bleu ir remote of QQ BOX on DVB VIEWER or DVB DREAM?

Diseqc problem solved?
What the solution ?

hello i own the qq-box the sharp one im running windows 32-bit and i install and when i plug the usb cable into my laptop it connect then disconnects and says unknown device or sometimes it will show in device manager Chinese symbols

well i did get it to connect and install the driver but everytime i connect i get the same as stated ^^


please help