Results 31 to 40 of 41
Thread: AMC6 OK today?
- 12-19-2009 10:11 AM #31
ADVERTS
Nothing new. It comes and goes at various channels on the mux, usually when there's heavy weather like the east coast is getting today.
90cm Fortec Star Dish with 9120B motor & Blue Blazer LNB & VisionSat IV200 - FTA
Old Radio Shack Deep fringe antenna, ChannelMaster remote control rotor & AntennaCraft 10G202 Pre amp- OTA.
SkyAngel IPTV for the wife!
- 12-19-2009 10:11 AM # ADS
Paying The Bills With Google Adsense Circuit advertisement- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
- 12-19-2009 10:41 AM #32
Question about NBC MUX CH 1
I have all 4 channels on 72W - AMC 6 but lost sound on MUX Channel 1.
Used to have sound on this channel but lost it maybe 2 or 3 weeks ago.
All other channels have sound when they have a picture.
Anyone else have this problem?
- 12-19-2009 10:44 AM #33
Others have commented on it. It's not just your setup.
90cm Fortec Star Dish with 9120B motor & Blue Blazer LNB & VisionSat IV200 - FTA
Old Radio Shack Deep fringe antenna, ChannelMaster remote control rotor & AntennaCraft 10G202 Pre amp- OTA.
SkyAngel IPTV for the wife!
- 12-19-2009 12:34 PM #34
the uplink for that mux might be in NY or DC and they are getting pounded with snow
noticed signal low todayUniversity of Minnesota-Duluth Bulldogs mens hockey team
Defending National Champions
current number 3 in the country (but doesnt mean much honestly)
number 5 in the pairwise (this means everything...top 15 teams get in the tourney)
Life is good
- 12-19-2009 02:13 PM #35
The mux transponder is very low for me today, hardly even there. Last night it was fine.
Other known active transponders on AMC6 seem to be unaffected.
- 12-19-2009 03:47 PM #36
- Join Date
- Jan 2nd, 2006
- Location
- upper Northumberland County, PA
- Posts
- 3,274 Thread Starter
Maybe the uplink site is snowed in. I haven't been able to get the mux for quite a while now on my undersized dish, but today GBN is also gone. I still seem to be getting an average number of feeds from the usual suspects though.
Dish 1000.4 Eastern Arc dish, ViP 622 with broken HDMI port
GeoSatPro 90cm dish, Sadoun PowerTech DG-280 motor, DMS Avenger PLL321S-2 LNBF, Solomend PVR-800 (Openbox S9) receiver
- 12-19-2009 06:28 PM #37
signal is back to normal now
University of Minnesota-Duluth Bulldogs mens hockey team
Defending National Champions
current number 3 in the country (but doesnt mean much honestly)
number 5 in the pairwise (this means everything...top 15 teams get in the tourney)
Life is good
- 01-09-2010 10:08 PM #38
- Join Date
- Jan 2nd, 2006
- Location
- upper Northumberland County, PA
- Posts
- 3,274 Thread Starter
Has the power level on AMC6 Ku dropped across the board tonight for anyone else? I haven't had the mux for a while on my 18" dish (I really gotta get a bigger 2nd dish, or motorize the 30"), but yesterday and today GBN kept disappearing too. Lots of feeds were still up though. But now tonight I have nothing, no fixed channels, no feeds. I'm only getting a signal strength reading on two frequencies, 11742 and 12195. Both of them show a high quality reading on my Coolsat but no channels will scan in. I tried TSReader on my Twinhan card and the first one shows 3Mbps of null packets and the second one won't lock. I went out and shoved the dish over to 74W and I got ONN and three feeds, so the LNB is fine. Then I put it back to 72W and I still only get the above two signals. I DON'T think they're spurious signals coming from the LNB, the switch, or the receiver, or else they wouldn't show a quality reading, right?
Dish 1000.4 Eastern Arc dish, ViP 622 with broken HDMI port
GeoSatPro 90cm dish, Sadoun PowerTech DG-280 motor, DMS Avenger PLL321S-2 LNBF, Solomend PVR-800 (Openbox S9) receiver
- 01-09-2010 10:35 PM #39
- Join Date
- Jan 2nd, 2006
- Location
- upper Northumberland County, PA
- Posts
- 3,274 Thread Starter
GBN just came back up, pounding in at 91S/78Q. Nothing else yet though.
Dish 1000.4 Eastern Arc dish, ViP 622 with broken HDMI port
GeoSatPro 90cm dish, Sadoun PowerTech DG-280 motor, DMS Avenger PLL321S-2 LNBF, Solomend PVR-800 (Openbox S9) receiver
- 01-10-2010 12:00 AM #40
11890 ----60/92
12053V --73/99 color bars on ch1 &4 nothing on other 2
12144V --90/99 GBN
weather is messing with you Jim
edit: those were on the .90Meter dish just now 11pm CIcon 550, Vantage 1100HD (thanks Stogie) on .90M primestar DG380 motor.10'Sami+GI650 for c-band.
CS5000 now on 1m primestar-polar mount backup system.
Avatar: Kepler20E, artist's conception, see NASA's Kepler Mission page:http://www.nasa.gov/mission_pages/ke...20-system.html
-
Advertising
- SatelliteGuys.US
- has no influence
- on advertisings
- that are displayed by
- Google Adsense








LinkBack URL
About LinkBacks
Reply With Quote

Forum Threads
Bookmarks