Thread: Pansat 9500HDX FW running in S9!

the aug 8th firmware may be a better choice.
It was less finicky than later firmwares.

Originally Posted by Long Hair

no audio on all channel's, or just the one's you added. The audio worked on my S9, but only checked on THE CW.

that was the with the default channel list,an important clue.
I made the mistake of using pvr800 channel editor to edit the channel list.
It was said you have to use the pansat channel editor,which showed some garbage when used on the openbox channel list, so I ignored that program.

9500hdx has clone detection,probably why some menus don't work.
info screen 11111 for the warning message.

Originally Posted by xtgold

9500hdx has clone detection,probably why some menus don't work.
info screen 11111 for the warning message.

That's probable why it shows an error message when I hit 111111? Anyone out there know how to make it clone safe?

that screen should also show the factory menu test,it is blank on my s10 due to being a clone.
A real s10 with s10 firmware shows the factory menu.

For those playing along at home,the altech set-one HD4U firmware will boot on a s10,but I can't figure out the universal remote codes to navigate.Their model tx-8000hd will boot also but with the same remote problem.The tx-8000 was a 2meg flash,which was interesting.As always,use the loader v2.0.0c to put the original firmware back on the receiver.
HD4u spits stuff out the rs232 port during boot if you use a terminal program like teraterm pro.It may be better on an old receiver like solomend 800,to get the tuner working.
Standard lzma compression on the maincode,no signs of protection_ic like the pansat 9500hdx firmware.Better looking gui from the limited views I had.

I read that the tx-8000hd firmware was compatible with Sand Martin Receiver DVB-3033-MP4. maybe you can find the remote code for this receiver?