L6.14 reboots 722

[Grumpy]

Ever since my 722 downloaded the new firmware, my DVR reboots when I try to manipulate any recording. I select skip/restore for example, it appears to hang for a couple minutes then reboots.

What's the deal? It was fine before 6.14

[kstuart]

Try pulling the AC plug, wait 30 seconds and plug it back in.

[Chuck14]

I'm getting the same thing on my 622. I tried pulling the power yesterday to force a hard reset but it's still doing it. Any attempt to use skip/restore or modify an existing timer in any way (including deleting a timer) will cause a crash and reboot.

[Chuck14]

I think I found a solution for this. I thought maybe something was corrupted in the timers, so I decided to try deleting them all and re-creating them. (I had about 40.)

Deleting them caused another crash and reboot, which I expected. The first time I tried to create a new timer (to start putting all my old ones back) it crashed again, so I guess it wasn't the timers themselves.

Then I figured it must be the program guide data that was corrupted. I remembered reading somewhere else that doing a check switch will usually cause the receiver to reload the guide data, so I did a check switch and it did sit there for almost 10 minutes fetching new guide data.

Then I proceeded to put back all my timers and not a single crash. Tried using skip/restore and no problems with that either. So I suspect that just forcing a reload of the program data by doing a check switch would have cured the problem without the hassle of having to re-add all my timers.

[Pepper]

Get Rid of this Ad! Register Today!

Bad guide data has been the source of many weird/inexplicable issues over the years.

[ronton3]

---

ADVERTISING BOX

---

I had a weird problem with OTA channels a couple of months ago and tried the usual fixes, I then did a reset to default from the menu and that fixed it, not a first option because of the hassel but not a hugh headache.