I NEED HELP PLEASE

[yert62]

Ok I'm trying to install a Dish Sat. "Dish Network 1000" it has two different "signal recievers" (not sure what else to call them) one says "dp plus" it has two recievers n it (110w and 119w) the other one dosnt say what sat it is although I would assume it would be 129w well any way 119w has two places for coax cables and 110w has only one coax hook up so I assume I have to have at least one hooked up to each, the one I'm assuming is 129w has two places for coax, I was told that I need a dp 34 switch,
im hooking this up at my river bak I'm only using one tv receiver in the camper it is a vp612 dvr



Please help!!

My questions are...
1 what coaxes need to be hooked up!?
2 do I have to have a dp34 switch can I just use a three way switch from Walmart?

Warning: This is an Old Thread This discussion is older than 90 days. information contained in it may no longer be current

[HIFI]

one cable from the smaller lnb to the single port on the dp plus, then a single cable from the dual side of the dp plus to the 612. be sure to run a check switch.

[HIFI]

Dish1000.pdf try this for info.

[MattG@ DISH NETWORK]

You don't need a DP34.

Connect the single LNB (most likely a DP Dual that picks up 129) to the "input" on the DPP twin.

Run one line from the DPP twin to the 612, and use a DPP Separator.

Here's a wiring diagram. Ignore the receivers that they are connected to (and the "148" listed on the single LNB), and remember to use a Separator on the 612

[yert62]

Get Rid of this Ad! Register Today!

Please put that in layman's terms. I'm an idiot ha ha.

[yert62]

---

ADVERTISING BOX

---

Thanks dish network. I think I've got it now.