32 IR Remote

[ross9]

Try to de-link, and re-link it again, and even reset the Hopper. I use a 32.0 with my Hopper (couldn't get the 40.0 to work my AVR)

Matt
Haven't had time to play with this for a few days. Done all of the above. I have 2 32 remotes that were linked to our 922. I am trying to link 1 of these as a second remote to a hopper that i will mirror with an outside tv. Both react the same when I link them.(on both Hoppers) They show they are linked but the remote will not work the Hopper. The #1 remote shows a green dot to the left of the remote name but not on the one I'm trying to link. Can I not have 2 remotes on a Hopper? I have read posts from people that have used a 32 but not sure they were a second remote. I have also taken the batteries out of the remote and tried differant ways to unlink and clear the remote. ???

[ross9]

Just found this:
ajohnson5

• HOLY CROW!!! I finally found the solution (after Dish Network techs couldn't figure it out over the phone). I simply changed the Remote number key (the "1" or "2" designation at the bottom of the remote) to "1". Presto-- fully working 32.0 remotes on my Hopper. I figured it was something simple. I hope this helps someone else!!!

[MattG@ DISH NETWORK]

Were you able to get it working? I know it is possible to have a 32.0 and 40.0 both linked to the Hopper at the same time (I have it setup this way in my home). I do have the "1" facing out on my 32.0

[ross9]

---

ADVERTISING BOX

---

Were you able to get it working? I know it is possible to have a 32.0 and 40.0 both linked to the Hopper at the same time (I have it setup this way in my home). I do have the "1" facing out on my 32.0

Changed to "1" facing out and paired with no problems. Everything working great.