Results 19 to 21 of 21
10-24-2012 03:04 PM #19
"Go To X" is a partial implementation of USALS. USALS is a two way communication between the receiver and the motor. "Go To X" is only a one way communication where the motor receives a command from the receiver.
When a device distributor does not wish to pay for the USALS license, the device typically instead uses "Go To X". A "Go To X" motor receives the USALS command issued by the receiver, but it does not provide movement verification communication in return back to the receiver.Satellite AV, LLC (Gold Sponsor)
Equipment Development / Distribution / Repair / Call Center
888-483-4673 - http://www.satelliteav.com
eBay Special Deals
Attention Installers: Want more work? Join the Largest Satellite Technician Referral Website - www.FTAinstall.com
10-24-2012 03:04 PM # ADSRegister Today & This Ad Goes Away! Syndicated Advertisement
- Join Date
- Advertising world
10-24-2012 04:11 PM #20Pub Member / Supporter
That explains why my receiver never seems to know when the DG380 & the dish stops moving.... I only know it is on location when the signal comes in!Migold -
10' Mesh BUD Dual C-LBNF w/actuator driven by Drake ESR1624U (61W-139W) and 90 cm GeoSatPro w/ DG380 (61W-125W) both to Azbox Premium Plus HD, & 2.4 meter stationary (aimed to 99°W) with (1st) Dual C-LBNF to AZBOX Premium PLus HD & Pansat 9200HD and (2nd) offset C/Ku LNBF (for 105°W) to Motorola-922 4DTV [Subscribed]. Viewing on Sony KDL-46XBR9, Sony KDL-32EX500, and other sets throughout the house. PLUS OTA VHF Hi-Band Yagi+Amp; HDTV Antenna w/Internal Booster from 'antennashopusa' on ebay; & 16 Bay AntennaCraft Super G-1483 (Gray-Hoverman) modified +Amp.
10-24-2012 06:20 PM #21
- Join Date
- Oct 2nd, 2012
- san diego
- Post Thanks / Like
- Thread Starter
It is a BSC621 and appears to be working rather well. Tried just using a single Ku LNB that came with dish and wanted more channels.