One Receiver Controlling Two Dish Movers: Help Request

[Babadem]

Two solutions:

1. Use USALS for KU-band and DiSEq1.2 for C-band
2. Use USALS and/or DiSEqC1.2 for KU-band and DiSEq1.2 for C-band. Assign different motor positions for the C-Band and the KU-band satellites. Example: If programming DiSEqC1.2 for both C and KU satellites, program 97w-KU with motor position 1 and 97w-C position 51, etc...

Hint: Make sure the DiSEqC positions are first erased from both the HH and the V-box before programming. Both devices currently have duplicate have saved motor positions.

I'm currently using solution1 and it is working fine.

[Babadem]

---

ADVERTISING BOX

---

I use a DiSEqC 1.1 Uncommitted switch in place of the switch you are using. Only one dish moves at a time. Hint: the uncommitted switch defaults to port one when off. I don't use port one. This way the DiSEqC commands are not recieved by a device on port one unintentionally. The switch I use will pass enough power for KU motor operation.

The Chieta 4X1 DiseqC switch does that beautifully for my setup.