Welcome HOME to SatelliteGuys! We are America's Most Popular Satellite Forum!
- JOIN US AS A MEMBER TO GET RID OF MANY OF THESE ADS INCLUDING THIS BIG AD BOX!!!
- This message (and many of these ads) will appear on every screen until you register! CLICK HERE to Register for FREE!
UPDATE: So I followed Primestar31's instructions and had my system up and tracking satellites in less than an hour. After moving between some satellites and getting good results, my dish alignment went out of whack. I believe this occurred because the motor shaft that holds the dish was loose from the factory and slipped slightly out of position. I made some changes to my active satellites and apparently tuned a channel on a deleted satellite and put my receiver into the continuous boot mode (I'm running 06/26/2013 firmware updated from the satellite and I definitely did a factory reset and unplugged the power cable for 20 seconds). Now I will buy the special cable and reprogram my receiver. More to follow when I get all this resolved.
09-03-2013 11:57 PM