Coolsat 4000 Pro & HH120

[White Cobra]

Trying to figure out how to program a Coolsat 4000 Pro to operate a HH120 motor. I have followed all instruction for installing motor and dish that came with the Fortec Star 100 cm dish package, but Coolsat has no instruction for using a motor. I contacted retailer for Coolsat, still waiting for them to contact me. But not holding my breath. Has anyone had any luck using a Coolsat and a motor. If so, could you send me a few ideas. If you need more info about my installation, let me know.

Warning: This is an Old Thread This discussion is older than 90 days. information contained in it may no longer be current

[aaron01]

---

ADVERTISING BOX

---

Not sure what you have tried so far, but try this: On the main menu go to Installation>Motorized Setting. You will see you can choose satellites there, as well as set your lnb type/frequency. Go down to where it says DiSEqC motor. There are options for USALS, 1.2 and OFF. Choose 1.2 or USALS. If you choose USALS you will need to put in the satellite location as well as your location (antenna position). I hope that helps, if not post back and let us know what all you have tried so far to get it working.