622 - Manual Call Outs???

[Cornstalkk]

Am I missing something in the manual or in the set up onscreen menu? I cannot figure out how to manually call out just to make sure everything is peachy with my new VoIP service. I have all outlets active in my house for it, and the receiver did verify that it had a dialtone and it was ok, but I cannot figure out how to do a manual test call. Does anyone know I would do so?

Warning: This is an Old Thread This discussion is older than 90 days. information contained in it may no longer be current

[psumattDE]

From the menu -
Choose 6
Then choose "Diagnostics" - I think it's either #2 or #3

Then, there is a choice for "Connection". Picking that will create a test call-out.

[Cornstalkk]

That is what menu I was mucking around in, and it just told me 'Dial Tone Ok' (or something similar). I did not see an option to actually call out.

[psumattDE]

You could also choose "Customer Support" from the MENU and this forces a dial-out call to DISH which pulls back your account info.

[Cornstalkk]

Get Rid of this Ad! Register Today!

You could also choose "Customer Support" from the MENU and this forces a dial-out call to DISH which pulls back your account info.

So, basically, if it pulls all that info from customer support, I am good to go? Because I did do that also, and everything was ok and my info was there.

[psumattDE]

---

ADVERTISING BOX

---

Yep! If it pulled back your info correctly - you just made a complete call.
You are good to go!