Recent content by dfwdish

Try going to your netflix account on another device and add a 4k movie to your watchlist, see if it shows up on Hopper Netflix

Yes, that is correct.

I confess it was me. I promise it was an accident. I missed the like button at the end of Scotts post and hit on yours instead.

I would like to upgrade to Hopper 3.!!!

Back to your original post. You do not need a terminator on the port if you do not have a joey. The purpose of terminating is to prevent over the air interference for the moca signal in the 650 to 875 mhz range. Since no moca connection is being made it doesn't matter if it's terminated or...

Everything is simple when you're not the one doing the work.

On both hoppers press the red button. Make sure both are showing 3 tuner lines. If by chance one or both of them is only showing 2 tuners there could be a problem with a duo node. If only one of them is showing only 2 tuners it may mean the tech only had a solo node and the hopper with only 2...

Mirroring with the Hopper/Joey system is not as simple as with a 722. At each HD tv location you will need to install an rf modulator. The feed from this modulator must travel back to your distribution on a separate cable from your hopper/joey signal cable. At your distribution this 2nd cable...

In his defense Anytime is one word.

I don't think in the cloud they would actually have to store every ones recorded content. Just a list of what is saved on their hard drive. Then the list points to their servers anytime a show is requested to be streamed to another device. This would also be very useful in the event of a...

I hope that setup is not outside the house. Several of your "drip" loops, actually allow water to run downward into your connections.

You only need a splitter on 1 isolator if you're isolating both joeys with 1 hopper. If you're isolating 1 hopper with 1 joey, just connect the cable for each joey to the client side of each isolator.

I'd just get a new wife.

If you're willing to unplug your joeys, you might as well just move the joeys to the locations where you want to use them. All 6 locations can be ran off of one or two splitters from wherever your distribution starts. Just put a 75ohm terminator on the wall outlet at each room that's not being...

If it should be easy to wire, go ahead and be finished wiring it before the technician arrives. Doesn't sound like free "STANDARD" installation to me.