Recent content by dishman007

  1. dishman007

    Can someone help me find signal on my own?

    elevation too low and to the west too much . move dish 3 to 4 marks up and back the south just a little 1/4 inch and then run check switch again
  2. dishman007

    How to get audio from VIP 612 to computer speaker?

    get a adapter from radioshack 3.5 to male rca's
  3. dishman007

    Antenna suggestion

    i use the winegard amplified sensor alot in your area with good results
  4. dishman007

    Appeals Court Finds Echostar in Contempt in TIVO Case

    pretty sure rates went up 2 cents for one dvr and went down for multible dvrs
  5. dishman007

    Installation - Motorhome and at Homebase

    issue will be with 1000.4 dish tuning rather than problem with 722. power #1 port from receiver and tune from the #2 port works the best for me. you really need a good self powered tuner sch as a sat buddy to make your life alot easier.
  6. dishman007

    Installing DPP Dual Tuner using DP Technology

    order a dp33 and swap out the 34
  7. dishman007

    Help Using Dish 500 for 61.5/72.7

    i have got it to work using same skew as 1000.4 in a pinch
  8. dishman007

    DVR 625

    try turning one side off when in dual mode, and see it works ok. if it works ok shut that one off and try the other side for ok operation. if problem exists only when both sides are on then problem will more than likely be the cable or connections, not the receiver.
  9. dishman007

    Wierd reboot occurance of my 622...

    unplug phone line for awhile and see if it still does it
  10. dishman007

    Moving to a neighborhood that doesn't allow dishes

    possible eastern arc might work better
  11. dishman007

    What is a good signal meter reading for the 625 receiver??

    could be the skew is off on your dish
  12. dishman007

    3 Months FREE Showtime

    dexter,weeds,and californication are some of the best on tv right now...
  13. dishman007

    301 Receivers

    always do a check switch : menu 6 1 1 select "check switch" and then "test" wait 10 mins. to a 1/2 hr for receiver to authorize.this is normal for receivers that have been unplugged for a certain amount of time
  14. dishman007

    Cancelling dish before installation?

    you have 72hrs even after activation,why would you cancel ??
  15. dishman007

    HD programming with a 921 and 622

    depends on the dish you are going to use
See more
Top
Back