Recent content by jmar

Thanks, the lights must have been on dim. I mistook that to be like starting over.

Please excuse my ignorance but I have written a PM to Matt but cannot figure out how to actually send it. Don't see anything to click on. Thanks

No brick alternate on 922

My receiver was also on Zulu time until the guide downloaded and then I had the correct time

I'm still showing EMM of 4160 but I have parked on G4 until I hear 'all clear'

I said that was 'back in the day'. Free feeds or backhauls used to be fairly common but a few couldn't keep their mouths shut about finding them and the providers scrambled them.

The fights were always high. Movies were about 3.99 if I remember right. Back in the day, I remember PPV asking $40-50 for viewing a match (don't remember who). I happened to come across the same match on a free feed. It was over in about 1 minute with a KO. Sure glad I hadn't paid to watch.

My 922 still had an EMM of 0 after a rehit so after about 10 minutes, I shut off the receiver with the remote and powered it back on and then had an EMM of 4160. I did not unplug the unit. Don't know if shutting it off is a necessary step but it seemed to work for me.

I have had the guide since I subscribed to programming and today I also have Info. I did not sub to the guide. I have a 922 and have not been shutting it off overnight. I assume that is no longer necessary.

LOL that appears to be above my pay grade. I have a 922 so I'm not sure that the cure would be the same for my receiver. I think that the article is describing my problem. I have programming. I can tune the receiver with the remote using IR but it will not respond to UHF at all. I have been...

Hi Jullius I PM'd you about my interest in one of your UHF remotes. At least I hope that I did. This old farmer is not too smart about sending a PM Anyway, I need to replace my remote for 922. Must be UHF Thanks

Did you try shutting down the receiver and restarting it again? Seemed to work for me.

Thanks. The IF function still works fine, just no UHF, so I really don't think that it is an address problem but I will try changing to a different code and see what happens. Edited to report that changing the address code did not help. I discovered that the correct code to enter on the...

Thanks for the reply. It is funny that my remote decided to act up just as my subscription came on. I was hoping that it wasn't caused by the new emm. Must just be a problem with my remote. Thanks again.

I just subscribed to programming from SRL and everything is coming in OK and I still have all satellites. The only problem is the UHF function of my remote seems to be gone. UHF is absolutely essential for my viewing. Has anyone else had this problem or is it just a problem with my remote?