Recent content by Kentl53

I checked with Samsung regarding there HL61A750 DLP and I quote: When the receiver (home theater) is set to On, you can hear sound output from the TV’s Optical jack. When the TV is displaying a DTV(air) signal, the TV will send out 5.1 channel sound to the Home theater receiver. When the source...

Sremick..... I checked and neither the 622 or 722 put out audio in dolby over HDMI if it is routed via the HDMI thru my Samsung DLP TV then routed to the amp via optical - it will not work......and has something to do with the DLP TV cannot put dolby out it's output....perhaps this is what you...

I read the link and thank you for steering me there. Interesting to say the least. It is really frustrating that DIsh Tech Support could not let me know this - you would think they would want to avoid sending out replacement receivers and keep their overhead down! I still wonder what it is...

Thanks for all your help!!!!! I will have to replace the old Denon AMP!!!!! It probably has something to do with it cannot decode whatever format NTGEO HD dolby is being provided in.....and that it does NOT have HDMI inputs......

I understand what you are saying, but I found that the 622 or 722 still (more than likely) is trying to connect via line cord. I tried your setup (hardwired to homelink then to another homelink) and plugged into power strip line surge suppressor. It worked, but the NAT table in the router...

Yes, that is the expensive solution I was trying to confirm.....Thanks! Before I go out and buy a new amp, can someone please confirm that the 722 or 622 now puts out dolby audio via HDMI to a HDMI input on an amp? There has been confusing and conflicting information in the past on...

I have tried changing settings to dolby/pcm dolby etc. and without any change. Even had a replacement 722 sent. Current version is 618....

That is the bigger problem......when I go straight thru (optical on 722 9r 622 to optical on the Denon AMP I do get the dolby, BUT I lose the audio on NTGEO HD, and a few other HD channels. I am trying to determine is it my AMP not being able to decode whatever audio format NTGEO HD using or...

I have tested both the 622 and 722 on the same system and I am sure they have the latest software......both do not pass dolby via HDMI when I route it to the Samsung DLP via HDMI and use the optical output on the TV to the amp? I do this since my Denon AMP(older) does not have HDMI inputs...

I have a 622 and a 722. They both work well using a homeplug setup. BUT keep in mind the ethernet port on 622 or 722 is ONLY for hardwire. The 622 and 722 route the signals thru the power cable into the wall plug.....AND if you are using a powerstrip can definitely weaken the signal. Try...

Need help! I have been gone around in circles with Dish Network. I have a VIP 722 using hdmi to Samsung dlp for video and optical from 722 to a 7 year old Denon amp. I get 1 second burst of audio about every 4 seconds on NTGEO HD, and a few other HD channels. All other HD channels produce...