Recent content by RicktheDbag

I though Eugene said a time or two that other firmware also could be placed on the HDVR3500 and never has expanded on that statement, At least give us a driver interface for chipset since the OS is opensource we could do the build for are self.

So it can be used with sling box network remote, MicroHD works HDVR3500 did not till now.

Now this is New and would double any person satelite with a multi switch set up.

hard and a mystery with out source code to descramble in short.

As I see much like the European STB makers, You need to be a STB maker only and have the box use a third party OS. open ATV, open VIX, HDMU, open MIPS, meny others, Will keep flack off you. But if open source software is used you should ensure that they supply the code, Which in Europe is just...

I have a prismcube-ruby and the XBMC is from the start part of the GUI, XBMC / linux is the over all OS for the system.

I have noticed with the 1152 firmware that the GUI locks up not the video from the satellite. If I leave the channel selection screen on screen for a long time the unit will not respond to the remote control, Requiring a hard reset with back switch. Also a lot of the IPTV will not connect or has...

Here is a question or request for the FTA mode, the IPTV loads XMLS files please request the capability to load .m3u files. Both files are some what the same but .m3u files are more common and supported.

Hi mike can we get a update on the 1997

I have the same invacom lnbf you will find if you test current that it draws a lot. Invacom, motor, and two diseqc and or 22khz is to much load, with out adding power from other source. The HH 120 is slow and I mean slow, about half the speed of other motors great motor but slow. As people have...

Thank you

I have a question sorry if it have been asked, how do I delete a channel. If I pick FTA the box always list G19, Astra 3A and I now have it on a single fixed disk not G19or astra 3A.

This multi switch is great for use and is simple to use. Use Dual output lnbf on fixed dishes and a small TV station is born. It has antenna input to power an antenna amp. so inside you use a duplexer and put a cable to TV tuner OTA and satellite in one cable. I supply free Satellite and OTA to...

I should say I use a Multi switch that supports diseqc control ( EMP centauri MS17/24 piu v10 ). It is diseqc 2.0 which is backwards compatible to diseqc 1.0. As all you have talked about is single output diseqc, to have a 24 output system that way would not be cost effective. the multi has it's...

I use a multi switch 8 dishes and 24 outputs, The firmware is the trouble as microHD works and the Manhattan 1997 which use some of the same code works. Cband = 5150 2port lnbf, Kuband= 10750 2port lnbf. All of this was covered in an early post. Also I see a lot of the Apps in xbmc have errors...