Search results for query: *

I have a diseqc switch I will split them and put some diaelectric grease in the open Ku port on my titanium. Thanks for the support

I have another quick question On my titanium C&Ku Lnbf can I just use the C band side of it and on my other dish use my geo sat pro SL1PLL for Ku band. Thanks

Thanks that’s what I’ll use.

Thanks for the reply, that’s was kind of the route I was leaning towards, do you have any recommendations on a C Lnbf or is the titanium as good as anything else.

First off thanks for the info on my earlier post, I wasn’t aware of the fact that I was between two satellites and you guys nailed it.Now I’m receiving 103w with good results. I do have a question though, I have a titanium C & Ku Lnbf and when I fine tune the skew on Ku I loose a couple of...

Ok thanks I will try and tweak it a little. Thanks for the info.

Yes I have the manual, but never seen anything for manual scan but after looking Through it I noticed I can do a NIT deep scan which I will give a try because the book says you can scan individual transponders there.

I didn’t unhook the switch because of thunder but I posted a few pics with Ku and C bands

At the start search line if you move left it’s TP scan if you move right it’s Satellite scan and then you have Blind scan. The line above it is where I select the TP and hit ok but when I blind scan it, seems like it scans all the TPS Not just the one selected.

If I have to add a transponder how do I find the frequency,I know the polar will be H or V but what about the symbol rate

The Manhattan has a list of the transponders for each Satellite and a lot of them I see on the satellite channel charts aren’t listed.

My list of transponder doesn’t show 3972V14800, I have a 3650V11705 at 80 sig Strength and 68 quality scanned the TP and nothing loaded also being a newbie What is SQ

I have a reading on H of 18.1 volts and a reading on V at 13.2 volts.

13/18 volt or on

Just 13/18 volt

I will give 103 a try as far as the skew I moved the lnb and adjusted it to the best Quality

There both stationary dishes in the Manhattan reciever it has lnb power on or off and gives you a drop down menu for the lnb settings as far as the readings go I haven’t taken any measurements. Thanks for the response

Hi all newbie here, wondering if anyone can clue me in on this problem. I have a 7’ dish for C band Titanium Lnbf set on and at 5150 and on 103W I only pull in 5 channels all on H polarity. I have a 30” dish For Ku band with a avenger Lnbf set on and at 9750/10600 on 101W I pull In one video...