Search results for query: *

Try going to the tv with the hdmi first and use optical to the audio receiver. I noticed going to the receiver first caused the delay. The tv seemed better about keeping them in sync.

Just use KillDisk to write zeros to the entire disk, unplug the usb cable from the machine and plug it back in. XP should say it needs to be formatted, choose ok and when it gets done, it will have full capacity availabe.

I had the same problem and found that hdmi from 722 to tv then optical from tv to 5.1 receiver made the difference. With the optical going directly from 722 to receiver, the audio was being processed quicker. When I set it up for audio and video to go to the tv by hdmi then optical to receiver...

In the guide..... for WNCF it shows that ABC is refusing to deliver signal unless they get a 160% rate increase prompting this move. I'm glad I get it OTA. It was just a slate, but they actually have an ad showing every so often that give a list of people to call including advertisers on WNCF...

-11 is pretty bad. They usually have someone come out if it's past -7 to replace the lnb.

Yeah.... You didn't perform the task correctly. The end result should of been a screen kinda like a memory dump in hex and no way of exiting it. You have to press and hold the front panel power button or pull the plug and reboot in order to get back to any programming. I've noticed you have...

try the NVRAM clear.... I had one local OTA that did the "Digital Service" thing and Dish played around with it since October 2007 and still didn't figure it out. As soon as I performed the NVRAM clear, re-scanned locals, and then a check switch to pull new guide data, I had all channels with...

It did on mine. All recordings and settings were gone.

In the Montgomery,AL DMA with my Vip 722 I have the same problem with OTA channels, but I managed to get mine to work so far without incident. Basically, I don't think it's something in the channel's data stream the receiver doesn't like, I think it is just a software problem in the way it...