I just got my AZBox Me, and had Fimwares RTI Enigma 2 ver.1.8 on boot(0) and AZtrino ver.1.6 on Boot(1) preloaded.
I was able to get the AZtrino ver.1.6 on Boot(1) working with my test Satellite (30.0°W) connected to a switch, but I need some help setting up the receiver using RTI Enigma 2 which is on Boot (0). I have tried both the Basic and Advanced Antenna Setup configurations without being able to see either Signal Strength or Signal Quality signals. For those of you that have the AZBox Me working, could point out what I need to do to get this going? If you could post screen shots of your setup, it would be highly appreciated. I plan to use this to run my KU Dish on a motor and my 2 fixed dishes. Secondly, do the firmwares, I listed above have issues handling DiseqC and 22khz switches. See my setup screen and let me know where I went wrong.
I also noted that the satellite list is mostly of European origin. What tools did you use to add the North American Satellites?
I was able to get the AZtrino ver.1.6 on Boot(1) working with my test Satellite (30.0°W) connected to a switch, but I need some help setting up the receiver using RTI Enigma 2 which is on Boot (0). I have tried both the Basic and Advanced Antenna Setup configurations without being able to see either Signal Strength or Signal Quality signals. For those of you that have the AZBox Me working, could point out what I need to do to get this going? If you could post screen shots of your setup, it would be highly appreciated. I plan to use this to run my KU Dish on a motor and my 2 fixed dishes. Secondly, do the firmwares, I listed above have issues handling DiseqC and 22khz switches. See my setup screen and let me know where I went wrong.
I also noted that the satellite list is mostly of European origin. What tools did you use to add the North American Satellites?