Hi, I have a used Von Weise actuator that I took apart to grease, and it appears that when I reassembled the end plate, the limit switch gear wheel did not get meshed with its mate in the same position as before. The result is that the tube now retracts too far (i.e. the limit switch isn't being hit).
I can easily adjust the upper limit cam (which sets how far the tube will extend), but I can't move the lower limit cam. How do I do that? Do I need to disassemble the back plate and re-position the gear below?
The limit switch design is the same as the one in the picture attached.
Thanks.
I can easily adjust the upper limit cam (which sets how far the tube will extend), but I can't move the lower limit cam. How do I do that? Do I need to disassemble the back plate and re-position the gear below?
The limit switch design is the same as the one in the picture attached.
Thanks.
