Great thinking! I had a very similar thought. It is a toy compared to the Venture 24".
Venture 24 actuator slack
- Thread starter pacificrim
- Start date
- Latest activity Latest activity:
- Replies 22
- Views 3K
-
WELCOME TO THE NEW SERVER!
If you are seeing this you are on our new server WELCOME HOME!
While the new server is online Scott is still working on the backend including the cachine. But the site is usable while the work is being completes!
Thank you for your patience and again WELCOME HOME!
CLICK THE X IN THE TOP RIGHT CORNER OF THE BOX TO DISMISS THIS MESSAGE
- Status
Great thinking! I had a very similar thought. It is a toy compared to the Venture 24".
It looks like I found a way to fix my Venture 24" - permanently or temporarily depending on the original cause. Time will tell.
So, I disconnected the actuator rod from the motor and noticed that I could press the shaft forward from either end. It would slack back and forth a couple millimeters. What if the actuator shaft was a better fit to the motor? So I used some small metal plates (pieces of a washer) to reduce the depth of the motor shaft into the actuator rod, thus pushing the rod forward. Taadaa!
So, I disconnected the actuator rod from the motor and noticed that I could press the shaft forward from either end. It would slack back and forth a couple millimeters. What if the actuator shaft was a better fit to the motor? So I used some small metal plates (pieces of a washer) to reduce the depth of the motor shaft into the actuator rod, thus pushing the rod forward. Taadaa!
- Status
Similar threads
