Ajak Motor proper maintenance

Vintagesports

SatelliteGuys Pro
Original poster
Nov 8, 2011
172
127
PR
Anyone know how to properly maintain an Ajak motor? It has a screw on top. Should I put some kind of grease through it? Does it need to be cleaned first from any old lube or do I just apply in it new grease? It seems to be working fine but does it need to be greased or lubed now and then?
IMG_7340.JPG
 
optical switch 009.JPG
If you want you can remove the reed switch cover plate (three screws) under that is a magnet wheel. It is held onto the shaft with friction. You can grab the wheel in the center with a pair of pliers and pull it off. Under that is that primary worm gear drive. You could put some grease in there. Not too much.
 
Hey I want that motor hevy duty were can I get one for sale motor only
There are not too many of these out there nowadays. Maybe with some luck you can find one attached to a HH cband dish. I was actually very very lucky to find one in Puerto Rico.
Good Luck!
 
  • Like
Reactions: FTA4PA
***

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Who Read This Thread (Total Members: 4)