Titanium Satellite signal or reciever issues

primestar31 said:

I don't have that exact receiver, BUT, arrow down to the bottom line that says: "Start Search" 'Blind', and then try arrow forward or backwards and see if there's a choice to change to "Transponder". If so, it'll also likely let you insert the exact settings you want.

You can look up specific transponders here: Satellite Charts - Search

But that site is NOT the be all or end all site (none are) so sometimes they can list something that's old, BUT, usually they are pretty much correct.

In other words, "Blind Scan" is typically always the first thing to try, followed by a transponder scan if it doesn't pick one up that you KNOW is likely there.

P.S. NICE setup you have there!

Click to expand...

Titanium said:

Make sure that when connected to the C-band LNBF that you select 103w C-band from the satellite list.

If you have any splitters or switches in line, remove and direct connect the coax from the receiver to only the C-band LNBF for this test.

Click to expand...

primestar31 said:

Go back a menu, isn't there a choice for "Manual Scan"? That's where you would do it.

Do you have the receiver manual? If not, here it is:

Click to expand...

Brct203 said:

based on the screenshots, looks like you are maybe getting a mix of 101W and 103W in Ku, and 105W in C-Band. That might also explain why you are getting certain things and not others. Maybe the dish is slightly off?

Click to expand...