I'm trying to move my VIP622 to an out of the way location. However, unlike with the TV2 remote, it seems that the main remote needs line of sight with the 622. Can someone suggest a way around this?
Thanks for the replies. I should have mentioned in my original post that I running in dual mode and, more importantly, I would like to continue using my Harmony remote.
Some TV's have an ir pass through. If yours happens to have this feature, you just need an ir repeater to plug in the back of the tv, then place the other end in front of the 622.
Thanks for all the replies folks! I think I'm going to give the X10 IR repeater a try and see what happens.
Another question...
How much range can I expect from the TV2 remote? My planned location for the 622 will put it one floor down from TV2 in the basement. I can position the 622 almost right below the primary seating position. Will the signal travel down through the floor?
Thanks for all the replies folks! I think I'm going to give the X10 IR repeater a try and see what happens.
Another question...
How much range can I expect from the TV2 remote? My planned location for the 622 will put it one floor down from TV2 in the basement. I can position the 622 almost right below the primary seating position. Will the signal travel down through the floor?
I've had one for about a year. I keep one of my Dish receivers in a closet, no line of site, and this works great. Only downside is that you need to install a little transmitter shaped like either an AA or AAA battery in your remote. If you have more than one remote for the hidden equipment, get a universal remote or additional transmitters. For most people, though, this thing is golden. It works so well, I completely forget about it. And, it is cheap ($34)!