Reply to thread

Message: [QUOTE="jashea, post: 2727388, member: 173107"] I am new to the forum. Thanks in advance for your help. I have a TV in the upstairs bedroom using a VIP622 receiver. I want to split the HDMI in order to keep HD TV to another TV in our kitchen which is on the floor directly below the bedroom. I was able to split the signal using 75' of HDM cable however I am having remote control issues. I have an extra IR/UHF PRO 6.3 remote. I was able to get it working on TV 1 while in the same room however when I go outside of the room it will not work. I tried running some CATV cable hooked up to the remote antenna but it still would not work. The remote works fine when using the TV2 out route, however it is not an HD signal. Anyone have any ideas on how to get the remote to work? The only thing I did not try is to have TV 1 off when trying to change the channel. [/QUOTE]

Top