Long time lurker - first time poster here.
Finally made the decision to try out this FTA thing and I'm awaiting the arrival of my new Conaxsat v1.
My current set up is a 10-ft mesh, C-Band LNB only and a DSR-922.
After reading through the many, many posts on this subject I'm still a little confused on how to slave the FTA box to my 922. I've seen the diagrams where the coax from the lnb is split and then feeds each of the rx's.
I've also seen a diagram where the loop through of the FTA box is sent into the 922, however I recall some comments made that the loop through should not be used in this manner (I can't recall where I read this, though).
I would appreciate any comments on either of these connections or any advice on how to do the connections.
Thank you,
RMS.
Finally made the decision to try out this FTA thing and I'm awaiting the arrival of my new Conaxsat v1.
My current set up is a 10-ft mesh, C-Band LNB only and a DSR-922.
After reading through the many, many posts on this subject I'm still a little confused on how to slave the FTA box to my 922. I've seen the diagrams where the coax from the lnb is split and then feeds each of the rx's.
I've also seen a diagram where the loop through of the FTA box is sent into the 922, however I recall some comments made that the loop through should not be used in this manner (I can't recall where I read this, though).
I would appreciate any comments on either of these connections or any advice on how to do the connections.
Thank you,
RMS.