Updating a DSR100c firmware - how to use the rs232 port?

[Wescopc]

With old firmware on a DSR100c, one can not change the TP frequency to upgrade the firmware/channels from the satellite. How would one update via a computer?:
Bob

 

[Wescopc]

I think I found the answer here at post 11:
http://www.satelliteguys.us/threads/150374-Glorystar-Firmware-Update-Thread
Bob

 

[KE4EST]

Yep that will tell what to do.

 

[Wescopc]

Well I did a RS232 update to GS_1.34 and D1.49 but no red button for changing the TP so that I can download the latest software/data from the satellite. Now what?
Bob

 

[Mr Tony]

The Glorystar models use 11842 as the transponder (which is different than the Micro). Is that what shows?

 

[SatelliteAV]

What firmware version is showing in the system or OTA update screen? 1.34 had the new updating transponder.

What transponder frequency is showing in the OTA update screen?

Power Cycle and perform a Factory or Master Reset after loading the firmware file?

Tomorrow, we will also update the thread and provide the most recent Firmware/channel list for RS232 uploading.

 

[Wescopc]

OK I went through it again - the RED "O" icon is there! Just on the page prior to where I was looking.
All went well! Look forward to the latest software to be added to this thread.
Thanks to all-
Bob

 

[Glorystar1]

Most recent Firmware and Glorystar Channel List for GEOSATpro DVR1100, DSR100 and DSR200 satellite receivers.

http://www.satelliteguys.us/threads/150374-Glorystar-Firmware-Update-Thread?p=3093077#post3093077