Recent content by alemmoe

I want to give a special Thanks to you for this information on advanced operation setup. I had trouble finding how to locate and get back to the Settings ,which it normally would do when turning it on for the first time. I am not finding how to add NEW frequency's, symbol numbers and pids...

I had ordered two more HDVR GeoSatPro 1200s and canceled the order when I discovered that the owners manual installation guide did not cover any steps to use these other two receivers for advanced operation for other satellites, other than GloryStar ,but I could get technical advise for...

I bought 3 GeoSatpro 1200s to replace my 3 1100s and am looking for a Advanced Operating Manual. The references to down load manuals on 1st page and last page of the 1200 owners manual installation guide covers the Micro HD ,but not the 1200. The 1200 has some new unfamiliar settings like...

I also am having trouble adding new channels to my one Geo Sat 1100 receivers and manual does not cover my issue. I have 3 GloryStar GEO SAT 1100 receivers and none is motorized ,but two are are set on other satellites besides Glorystar. I have been adding numerous new frequency's and...

stop the wasp and bee invasion I had a large nest of small aggressive bees inside my storage barn door and I could not go in after them. After trying two cans of wasp spray and they were still flying. I got the wet/dry shop vac and stood the hose and pipe against a ladder so the end of pipe...

I just saw this on craigslist -Philadelphia,pa. It was taken apart for easy transporting. http://philadelphia.craigslist.org/tls/3482397589.html.

I Want to Win!!

I grew up along the Squehanna River in Central Pa and loved wading in the shallow water and lifting rocks to catching Craw Dads. My step brother built me a boat by bending plywood which I propelled with a long pole and it would allow me to explore the islands in the middle of the 1/2 mile wide...

If the fix does not do the job,I have a brand new Von Weise motor,7 1/2' Dish Package, that was bought in the early eighties and never put into service. It was sold by Radio Shack. Al

Takoulis: I ran a automatic copy wood lathe for twenty years and I also needed a bronze bushing reduced for a project. I turned a wood blank into a dowel that I fitted tight into the bushing ,found the centers on each end and used a fine large file to reduce it to the correct diameter with two...

Takoulis, Sorry,But I only looked at the rusty metal. That really got my attention because I use electrolysis [water and a battery charger] and have dipped the Dish parts into a 2' x 2' x 4' deep square [ plastic only ] tank,for a day or two, with a commercial battery charger with 65 amps...

Takoulis: If you are not able get your rust bucket back into operation,I know where there is a complete new/ Old Stock, H to H ,complete Dish,Motor,cables assembly that has been in storage since 1983, that is for sale. No rust remover needed.

" I want to win the all new FastAlign 7100Pro signal meter with AutoFind technology exclusively from LEXIUM " It looks like it is simple to operate.

I have three of these GeoSats, two DSR 100s and a 1100 to get both the Glorystar programing and the advanced mode. I am thoughtly confused on how to get both on together and with a menu. I always kept the OTA off so a download would not wipe out my advanced mode programming. I do not do any...

I have decided to sell the Whole Radio Shack/Von Weise Satellite system minus the Analog receiver on Ebay because It was over whelming for me and I could not find anyone local to set it up for me.I did find one person who I could pay to find the Clark ark when using the standard type motor.