Yes! I did it and it works, I got the new motor up and running and get 74.oW all the way to 125.oW. The motor is a SG9120 Powertech from WS International. But the only problem I had was that my Nfusion HD receiver was moving the motor but would not stop and lock. So I went and got the Fortec Star Dymanic receiver and and used the USALS and started with my ture south sat 89.oW Galaxy 28 bingo! then 97.oW Bingo!! and so on from ONN to PBS.
I took the receiver's out side to use and the Sat Hawk 5000 meter too. Over the last three days I spent about 12 hours working on it but today I won this battle now the next one. The next battle is to Re-Plumb the pole that is mounted on the roof so I can move the dish & motor back up there. I do need to tweak the signal a little right now (SS 77-83%) (SQ 45-70%) the signal quailty is a little low.
I do have this question? Will a DMX741U C/Ku band LNBF work some what well on a 90cm dish?
But all in all I say "I did it!"
Musher
I took the receiver's out side to use and the Sat Hawk 5000 meter too. Over the last three days I spent about 12 hours working on it but today I won this battle now the next one. The next battle is to Re-Plumb the pole that is mounted on the roof so I can move the dish & motor back up there. I do need to tweak the signal a little right now (SS 77-83%) (SQ 45-70%) the signal quailty is a little low.
I do have this question? Will a DMX741U C/Ku band LNBF work some what well on a 90cm dish?
But all in all I say "I did it!"
Musher