No signal on a Dish Network DVR 625 receiver

Discussion in 'The DISH Forum' started by rebm58, Oct 19, 2012.

  1. rebm58

    rebm58 Thread Starter New Member

    Joined:
    Feb 5, 2009
    Posts:
    1
    Likes Received:
    0
    I have a 322 Duo Dish Network receiver that works fine. I recently bought a used DVR 625 receiver and installed it instead of the 322, but I don't have any image on the channels I just have the program guide. When I get into the antenna screen there is signal strenght only in Sat 119 and none in 110. Then I went to the check switch screen and noticed that there were 3 Sats saved( 110, 119 and 129) and in the 322 there are only 2 (110 and 119). I don't know if that is the problem, and if it so, please tell me what to do to have just 110 and 119.
     
    #1
    Avatar

    Advertisements Register Today!



    Reigster at SatelliteGuys
  2. TheKrell

    TheKrell SatelliteGuys God
    Pub Member / Supporter

    Joined:
    Jan 4, 2007
    Posts:
    10,573
    Likes Received:
    277
    Did you do a check switch? Once that's done and you have both sats, did you call Dish to get it authorized?
     
    #2
  3. maryb@Dish Network

    maryb@Dish Network Official DISH Network Support
    DISH DIRT TEAM!

    Joined:
    Dec 29, 2010
    Posts:
    1,245
    Likes Received:
    5
    If you are still having an issue, please Pm me directly with your account or phone number and I will assist you further. Thank you!
     
    #3

Share This Page

VigLink badge
Sucuri