Recent content by fordman86

well got quad lnb back installed and left dp34 switch with only the 625 and 510 installed so far. Going to test this way and see if I get the error message. If I do will see if there is a number code on it.

I am just getting ideas from you all to try. See the 322 is just on a basement tv so not improtant but do want it hooked up. So all your help is mush appreated very much. yes I ment twin lnb don't know all the terms. Try to do stuff when everyone is off to work and at school but when it doesn't...

I have my old dual lnb back on. Also have the switch hooked back up and running the 510 and 625 to see if I have any trouble. One line to 510 and 2 to 625 no 322 hooked up. How can you tell the switch is bad recievers still se it.

Two lines off the lnb into switch Line one to 510 line 2&3 to 625 Line 4 to 322 Everything worked but would get a big red ERROR saying lost signal didn't see the number but would get it on the 510 and the 625 various times. I understand now why the 322 was the worse one. But the 510 and 625...

so that would effect all the others? Who knew :confused:

so do you think running the 510 625 and only a single line to the 322 was causing all my headache

So in order to make everything work I need to put 1&2 from lnb to the dp34 then can I run just one new line in and take one off the dp34 and the new line and go to the 322. Is the 322 my trouble why I am getting errors on the other tv's? where I have both lines going to switch and one to 510 two...

well I know it doesn't do PIP but only need it for one tv do I just connect one input or is there something in settings.

does the 322 have a single mode?

Ok here is my story I have had a dish 500 along with a 510 and a 322G recievers running fine. But wanted to add a 625along with the other two. I bought a used dp34 switch and hooked everything up one line to the 510 two to the 625 and one to the 322 Wanted single mode but think was in dual...