Recent content by iceroadman

thank u very much guys. i guess the first time i connected to 97w i must have been lucky cause to find it again was pretty tricky, just a hair one way or the other and no signal. but i have it back again so, again, thank you to all u guys who tutored me.

i already have a B*V dish, dish network twin lnb's can i just use any of the two coax coming from it

also is there some way to put the software back to the original state that the receiver came with, maybe i have screwed up the OS somehow.

thanks again....... i have a fixed dish. for the Nfusion HD i have also reinstalled the factory bin and then upgraded again to the newest bin file i could find. i have up to 99% signal strength depending on which TP i select. on the CW700 i will get about 4 beeps from the quality if i turn the...

i'm pretty sure i have the dish pointed correctly, pretty much the same settings as i had it when it was receiving 97w the box is set for 97 w, lnb is set to 10750 most other settings are off as i have no switches just straight to the lnb i've scanned all the tp's, done a blind scan with not...

thanks thanks for the help guys, took the tv and receiver outside and hooked it all up to the dish on a 5' coax then did numerous adjustments to the dish but not quality. the nfusion hd doesn't seem to have a setting in the software to turn the lnbf on or off so i take it that it is on by...

signal i have from 89 to 91 % on the signal from the lnbf depending on what tp i am selecting with the coax disconnected it has about 30% showing the first time i had it receiving 97 with all the channels it has about 82% on the signal and about 80 on the quality

equipment Nfusion HD Nuvenio CaptiveWorks CW-700S 36" Fortec Star Satellite Dish Dreamstar FTA Linear Dual LNB coax is identical to the stuff bell installed with their setup I had both of these units receiving 97w until I tried to look at another sat. had no luck with that so i...

is there any way to check to see if the receiver is actually receiving a signal from the lnbf. or to put it another way, to check if the receiver is damaged or not :confused::confused::confused:

I do have it direct to the box with no disqc switch. one box on one connection to the lnbf and the box on the other connection

any ideas is it possible to fry the receivers circuits that receive the lnbf signal???

I have two receivers, cw700 and a nfusion hd, had both up and running pointed at 97w I realigned the dish and tried to pick up 83w with no luck so i realigned the dish back to 97w and could not pick up 97 again. At the same time i connected the nfusion to my bev dish through a diseqc with 91 on...