Recent content by jdward

Do you think moving the DP34 switch within 25' of the receivers and inspecting the cables will do the trick? Right now the system is set up with two dishes with the single LNBs. The dishes are approximately ... don't know for sure but let's say it's about 100' from the first DP34. A second DP34...

Did you ever get this problem worked out? If so, what did you end up doing? I've got a similar situation with a cable run in the 400' range using a DP34 switch about 100' from the LNB. I'd like to move the switch closer to the two furthest receivers. Maybe that will take care of the partial...

What does "having trouble" mean? Does it ever switch between satellites? Is the malfunctioning receiver the one on this phantom 3rd DP34? Difficult or not, I think you are going to have to locate that 3rd switch and see how it's hooked up. The DP34 has 4 receiver outputs which switch, and 3...

Dish Pro dosen't use switching voltage that was the Legacy systems, Dish Pro uses band stacked technology to send both odd and even channels down the coax at the same time. Tell us about the 7th receiver and connections on the second DP34. Is this receiver with the problem switching satellites...

I am working on a satellite system that is using seven 301 receivers. The system uses two DP34 switches with three receivers connected to each switch. There are switch output cables on the second DP34 that must go to a 3rd switch which powers that last receiver by itself. A couple of the cable...