Recent content by kcoutlaw

That helps !! ;) Thank you !!

The FTA List. Sorry !

Hi guys ! On TheList, I see highlighted boxes, and colored fonts. It would be helpful I believe to add at the top of the page what these indicate. I am assuming that the red text indicates a encrypted channel, but not sure. Just a suggestion ;) KCOutlaw

Thought that was the one it was on. Tried dialing in 103W, but could not bring it in. May be due to my location. Might try again after it warms up a bit.

Thanks RT ! That is the plan !! Bigger KU band dish, and a 8-10 foot BUD. ALL on the ground !! LOL.

Thank you and your welcome ! I am pointed at G19 97W. Don't think COZI is on that sat. At least I don't see it on the channel list. But I get COZI OTA, so I am good ;)

Hi Dan ! Below is a pic of the signal info on Russia Today. It is a little low today. We got some snow. Most of my signal readings are 80%+ and quality averages about 50-53% across all received channels. Think it might need just a little tweaking, but will wait till it is nicer out :)

Glad to post them. Amp?? You mean the antenna amp that is in the pic with the Receiver?? That was to my OTA Ant. It is Disconnected. Didn't need it. Thanks for the tip tho !!

Ok everybody, I said I was going to get some pic's of my Slimline KU Conversion last weekend, but got busy and kinda forgot :rolleyes:. Anyway, here they are. (See Below ) Just for a reminder, this is a list of the equipment: DTV Slimline Dish. X-Squared X2 Premium II HD Satellite receiver...

Thanks !! Actually, I just used the hole that was already there for the DTV SWiM LNB on the left side. Think I told you I had the rectangular arm without the flared end. WRONG. haha. Same one you have. Just got back in town. Was spending time with the family for Thanksgiving. Will post some...

Thank you TI !

Thanks toucan-man ! I'll check that one out !

Ok folks, Here is an update on my DTV 500 Slimline KU Band FTA conversion- With a lot of head scratching, and trips up and down the ladder, and a lot of advice from the folks here, the project worked ! My initial problem I believe was a combination of a few things. First, I had the elevation...

Ok, Got everything installed and fired up the receiver. Now I have an issue. All sat's that I can get are showing from a 45%-80% signal. However, when I blind scan, it does not pick up any channels? I have a feeling this is a "operator" issue. I have tried several scans, but up till now no...

kodaz- Seems to me I read that somewhere. Might have been in this forum, don't remember :wacko: Anyway, I am using just one LNBF for this experiment, so ( fingers crossed) I am hoping there will not be any issues.