Recent content by MagnumVP

If I output from Red/White/Yellow don't I lose the 1080p? Isn't R/W/Y only 480i?

How do you "Mirror" the setup?

It's not charged to their Dish Account. That is the amount they wrote the check for to the 3rd party installer. There is also something that seems "off". When my parents call up Dish, they tell them that their bill is going to be $195 per month (My parents get every program possible)...

They are both Hopper with Sling.

I agree. Sometimes I just want a list and don't really care to see the images. I'm guessing it would also improve performance since it wouldn't have to render all the images. I think they just need to add it to the options on top. Order By List...would be nice.

I'm writing this for my parents who are going through the upgrade process now and I think are getting raked over the coals for the cost. Their old setup used Home Distribution with their 722 to get it to all the TV's they wanted to watch from. They are upgrading to the Hopper with Joeys and...

Is it possible to change the standard DVR show list from image based to just a list organized by folders?

No sure if it matter but here is the DiPlexer that I used and it works perfect.

SUCCESS!!!! I was able to get the Joey and Hopper to work via the Ethernet switch AND the OTA Antenna to be seen at the Hopper.

It seems to work just fine when I set it up like the image on the left. I get both Sat and Antenna. How do I go about "kill" he moca signal? Do I even have to?

Thank you. Both locations are running Cat 5e cabling with a Gigabit switch.

That may work then. If I unplug the Joey from the Coax and plug it into the Ethernet network. I can then plug in the OTA antenna (just like the diagram on the left in m first post) and get OTA on the Hopper via Coax and then steam to the Joey via Ethernet. I'm going to try it and see if it works

I have a APC Smart 1500 that powers my TV and my Hopper. Its been this way since I've been with a receiver with a DVR without issues. During power failures I'm the only house without power but watching TV. :)

Thanks for the info. I guess I'll just disable PTAT since I have timers for everything that I need. Thanks

Is it possible once the Joey is setup via Coax, to run the Joey over my Wired Ethernet if both the Hopper and Joey are connected? Edit: I found in another thread that this is possible. Is there anything that I should be aware of regarding this change?