Recent content by mardebo

  1. M

    install vip622 bad switch

    Replaced a couple old crimp on connections w/ compression and everything looks good to go. Thanks for the help everyone!
  2. M

    install vip622 bad switch

    nope, new feeds. I even tried disconnecting the line feeding the existing 622 and plugging into the new one and got the same message.
  3. M

    install vip622 bad switch

    Ok, I am going to attempt to make this as simple a question as possible. I currently have a vip 622 reciever on a HD TV and it was sending a SD signal to another TV. I replaced the SD with a HD TV and got another 622 from dish. When I run the check switch it goes to to step 1 of 38 (too many...
  4. M

    Swtch error Dish 301

    so there is no way to do it with just one co-ax eh? Why did it recieve both 119 and 110 before? Would a different reciever work? Thanks for the help so far!
  5. M

    Swtch error Dish 301

    I had the lines from the dish combined to one. It (the 301) recognized both satellites before, but now will only do one at a time and when I run the check switch it says "warning, only one satellite recognized" when it didn't do that before. The 501 works fine and if I have it set on a...
  6. M

    Swtch error Dish 301

    I have a DPP 500 dish and LNBF at my second residence with a 301 reciever and a 501 DVR reciever. I could only watch the same sat (110 or 119) that the 501 was tuned to or I got the error code "switch error". In an effort to correct this, I ran a check switch on the 301 and got a message...
See more
Top
Back