Recent content by paisley_tele

why is it everytime i connect the home distrubion cable to the cable line it cause everything to be fuzzy? how do you hook up 2 sat boxes and baisic cable to home cable wiring?

how can i hook up the two reciver so i can watch both reciver on all four tvs. i have splitters wired up right now but if i try to watch tv on the tv's that have the dish boxes wired to them the picture is fuzzy. its all wired up like a basic setup but i added a splitter to the wire the runs...

how do you get the 508 to output on a higher channel. and what filter is good to use

how do you get the 508 to output on a higher channel. and what filter is good to use.

i treid that but the basic cable over powers the 508 any way to stop that. i get free basic cable with my cable internet and i sue some of the locals that dish dont get. how do i override channel 3 to get the dish on it

so if i take the 508 cable output to tv and put a splitter on it , then run it in to the tv wall cable i will get the 508 on either 3 or 4 and the 722 on either 77 for tv1 and 79 for tv 2 from any where in the house. is that correct?

is there anyway t ties a 508 into the home cable. like the 7ss uses 77 and 79 channels how do i get the 508 to do that

i have a 722k hooked up to 3 tvs. i would like to watch dvr programs on the 3rd tv which is the same as tv1. now on the 3rd tv i also have a 222k hooked up. is there a way i can use either a 21.0 or 6.3 remote to control the 222k on ir and the 722k on uhf by either flipping a swicth or key . or...

here what i got! The installer install a 722k dvr and a 222k. they are both dual tuner just on does the recording (722k). so i have the 722k in the living room then is back fed to the tv2 up stairs, Same way with the 222k hd down stairs and standard tv upstairs.Now tv1 and tv2 on the 722k get...