Recent content by palmosaddict

  1. P

    1 motor + 3 DiSEqC 1.2/USALS receivers

    Hi, Anole! You are right, this seems closest one can do in this situation. I prefer solution 1) as one can do it with remote :). In my case 2) is little bit cumbersome, as both Humax receivers do not have on/off switch, so you have to plug them in/out or, better, introduce extra power...
  2. P

    1 motor + 3 DiSEqC 1.2/USALS receivers

    Hi, I think I finally traced down the real problem here (thanks for your comments that redirected my thinking). I was doing some experiments over the weekend, so here are the latest conclusions. Once the motorized system is setup by USALS with one receiver, it works automatically with any...
  3. P

    1 motor + 3 DiSEqC 1.2/USALS receivers

    I forgot to mention, my three receivers are looped-through at a single site, all of them feeding a single TV.
  4. P

    1 motor + 3 DiSEqC 1.2/USALS receivers

    Hi! Thanks for your attention! One receiver must receive (first provider) from Intelsat 10-02 (1.0W), the second receiver (another provider) from Hotbird 6 (13.0E). With my original (bought first) box I sweep from 28.5E to 12.5W. I do not have place for three dishes (living in a flat, hardly...
  5. P

    1 motor + 3 DiSEqC 1.2/USALS receivers

    Hello, guys! I have three DiSEqC 1.2/USALS receivers (rather do not ask me why: one of them is due to a provider that bounds its smart card to its own STB, so the "clever" investment in STBs with CIs does not looks so clever at the end). But the problem exists even if you have only two DiSEqC...
See more
Top
Back