Recent content by Rab669

My line of sight is clear. Is it possible to hit 61and 72 with the double lnb and not use the single outside one for that? I thought the double is lined up for 77 and 72.

Whatchel1 Is the order under check switch the same as the lnb. I should see 77 then 72 then 61 in that order? I covered the two outside lnbs with foil and verified 72 was the only sat I was seeing

I have an LNB that has 1 double and 1 single. When I run a check switch it shows connection to 72 and 77 and the 3rd connection has a red x. I have no idea what transponder I am checking for 61. I will look at it this weekend when I am back home. What transponder should I be checking.

Anyone know if there is a way to test 1 one of the lnbs without a meter. I would think if I'm getting good signal of 2 of the lnbs is should see something on the third?

I'm starting to think the 61 lnb might be bad. I covered the two outside lnbs and verified signal on 72 with the center lnb. I have 50 signal strength on 72 and 70 signal strength on 77 but nothing on 61. I have 2 cables from Port 1 and 2 into a solo node. I would think if I'm getting...

Also.. If I want to get 61 sat do I have to have a cable coming from Port 3. The manual says port 3 is used to output sat 61. I was told I o ly needed 2 cables into a solo node if I'm just running a hopper only. I'm plugged I to port 1 and 2 currently.

So I should be able to cover the 2 outside lnbs and I should get 72 sat only. I have a suspicion I'm pointed to 77 and I'm get 72 on the lower lnb and missing 61. The thing that seems odd is that when I check 61 it says I'm pointed to wrong sat and shows the 77 sat which I am getting g fine...

Trying to do a self install Setup: 1 hopper 1000.4 dish with 2 cables plugged in to port 1 and 2 Solo node with both cables plugged in with a single cable going to receiver Signal of 50 on sat 72 Signal of 76 on sat 77 When I check signal on 61.4 is displays wrong sat and tells me...