Recent content by sar2012

Thank you for the advise. My dish is clean.

Yes, I will fine tune the dish and adjust LNB when the Sarnia weather is warmer. Thank you to all of you for advise.

The followings are previous transponders that are not good anymore: 11874, 12060, 12090, 11789, 11836, 11867, 11808, 11997, 12022, 12177, 11912, 11998, 12029 and 11961 MHz. The following are good transponders from my last Detailed Blind Scan: 11842, 11936, 11966, 12122, 12152, 11929, 12053...

Yesterday night, the detailed blind scan helps to bring back all channels. It works like before now. As I still have the list of previous transponders in my Satlink, I will check and compare blind scan transponders with previous transponders. Look like only one of them unchanged while all other...

I drilled a hole through the disk holder when the disk was well aligned. This hole is drilled trough the up/down plate, left/right holder and the stand pipe. The holes of the plate, holder and stand pipe are still well aligned. I did try to find better new position by moving the disk around...

No Signal on Galaxy 19 I have no signal on Galaxy 19 several days ago. I am in Ontario Canada. Yesterday, I came out to check my 36" satelite disk using my Satlink (electronic satelite finder). Autoscan of Satlink found 13 TV channel at the current position of the disk. No improvment by moving...

I bought Satlink WS6906 last year (see link below) and use it many times for myself and friends. It's work quite good and reliable. When it locks to your satellite, you can watch the channel you like on it screen like a TV. http://www.ebay.com/sch/i.html?_nkw=satlink+ws+6906 Somme little...

rv1pop, You are right. My program settings are at "channel"!!! I discovered this yesterday night and changed them all to "record". Every things work fine after that. Satellite RV, I did my manual firmware update succesfully following your instruction. I got a little difficulty to do it as my...

I alway shut the unit off by unplugging the power cable for 20 seconds. I did shut the unit off and restart it then did a factory reset, reinstall satellite and all channel. After that I did shut the unit again and set all 6 preprogrammed settings. These setting are 58 minutes Daily for the...

Yesterday, I tried to use my USB 32 Gi Memory Stick in place of hard drive. MicroHD does not record any preprogrammed settings!!! Like the hard drive, I can manually record a broadcast. So the problem is of the MicroHD. May be the new firmware will help. I will try to manually updates firmware...

I will try Memory stick. Yes, I tried twice to disconnect the power source for 20 secondes and also tried to perform a factory reset but failed many times to run manual update via satellite. The drive is a WD 500 Gi Passeport (pocket size) that does not have 2nd USB connection. This drive...

Yes, I always set the clock to GMT off and set date and time manually. I reformat the drive with my computer. The MicroHD can record when I press the RECORD button but refuse to record on the pre-programmed setting. I did try to format the drive with MicroHD but cannot find this command. I...

I am using a new MicroDH for many months for recording broadcasts to my 500Gi hard drive without any problem. Note that I always left MicroDH on 24/24. The box was set for monthly auto updating firmware. Yesterday, the box did not able to connect to my USB hard drive (only a green light is on)...

Yes, I do turn it off and on. So I will let it on all the time then. Thank you very much.

Set GMT to OFF gives clock error every day thus I have to set the recording timer to 5 minutes in advance and come back to change the time every week. Otherwise I will miss the beginning of the recorded transmissions!!! I hope that the new firmware will correct this problem.