Recent content by satellitemike81

The 99 and 103 satellites are not read on the birdog due to the frequencies being different. He may need to use the dither to fine tune the dish.

The DPP33 will not work unless he is using 3 separate Dish Pro Dual LNBFs (the DPP33 does not work with DPP LNBFs). I don't think the DP34 will work, but even if it did it will take away your ability to use DPP separators, meaning that 2 lines will have to be run to each Dual Tuner. The only...

You would need to cascade to another DPP-44 switch

You can never count on Customer service. All they know is what is on the screen in front of them. As for your installer he obviously didn't know what he was doing. He should have done a check switch before leaving. That would have told him that your dish was not the proper dish.

Yes the LNBF you have is fine. Try switching the box locations to see if it is an issue in the line, splitter, etc. If it doesn't change on the HR23 then it sounds to me like your dish may just need to dithered a little bit. You could just be picking up signal on the 101 satellite and not...

Here it is 99.99 shipped. Just click on the link

They will set you up with either a 1000.2 or a 1000.4 dish depending on where you are located.

If you did that you would receive HD in the second room but would not be able to watch seperate programming. The only way to watch separate programming off of one receiver is if the second tv is in standard definition

The first dish posted is what you need for your locals. The second dish is a phase III which does not pick up the 99 or 103 satellites

The only way of getting away with connecting to only 1 sat port and getting the full functions of your receiver is if you have a SWM capable HD DVR and are using a SlimLine dish with SWM capabilities

This is the phase III dish for satellites 101, 110, and 119.